Lexus NX: Side Camera LH Internal Circuit (C2A61)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System / Side Camera LH Internal Circuit (C2A61)
DESCRIPTION
This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A61 | Side Camera LH Internal Circuit | A signal indicating a malfunction in the side television camera assembly LH is detected. | Side television camera assembly LH |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC C2A61 is not output.
| OK | .gif) | END |
| NG | | REPLACE SIDE TELEVISION CAMERA ASSEMBLY LH |
READ NEXT:
Side Camera RH Internal Circuit (C2A62)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication. DTC No. Detection Item DTC
Back Camera Internal Circuit (C2A63)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Det
Back Camera Response Malfunction (C2A6A)
DESCRIPTION During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR UPPER COIL SPRING INSULATOR LH *a 10 mm or less (a) Install the rear upper coil spring insulator to the rear coil sprin
Thermostat (P0128)
DESCRIPTION This DTC is stored when the engine coolant temperature does not reach 73°C (163°F) despite sufficient engine warm-up time having elapsed. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P0128 Thermostat All of the following conditions are met
© 2016-2026 Copyright www.lexunx.com
