Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL ABSORBER CONTROL ECU
(a) Install the absorber control ECU with the 2 bolts.
Torque:
8.5 N·m {87 kgf·cm, 75 in·lbf}
NOTICE:
- Avoid any impact to the absorber control ECU.
- Do not drop the absorber control ECU. If it is dropped, replace it with a new one.
(b) Connect the clamp to the absorber control ECU.
(c) Connect the 2 connectors to the absorber control ECU.
2. INSTALL PARKING BRAKE ECU ASSEMBLY
Click here .gif)
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.
Click here
5. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
6. INSTALL DECK FLOOR BOX LH
Click here
7. INSTALL REAR DECK FLOOR BOX
Click here
8. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
Tire And Wheel
RemovalREMOVAL PROCEDURE 1. REMOVE WHEEL ASSEMBLY (a) Loosen the axle hub nuts approximately 90°. (b) Lift up the vehicle and remove the axle hub nuts and wheel assembly. InstallationINSTALLATION P
SEE MORE:
Startability Malfunction (P1604)
DESCRIPTION If the engine does not start or it takes a long time for the engine to start, despite the ECM receiving the engine start request signal from the hybrid vehicle control ECU via CAN communication, this DTC will be stored. Read freeze frame data using the Techstream. The ECM records vehicle
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE HOOD INSULATOR (a) Using a clip remover, remove the 7 clips. (b) Detach the 2 guides and remove the hood insulator. 2. REMOVE HOOD TO FRONT FENDER SEAL LH (a) Using a clip remover, detach the 2 claws and remove the hood to front fender seal LH.
