Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
(a) Connect the connector.
(b) Install the back door opener switch assembly.
2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here
4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
5. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
6. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
7. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
8. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
9. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
10. INSTALL BACK DOOR SIDE GARNISH LH
Click here
11. INSTALL BACK DOOR SIDE GARNISH RH
Click here
12. INSTALL BACK DOOR CENTER GARNISH
Click here
13. ADJUST REAR TELEVISION CAMERA ASSEMBLY
Click here
READ NEXT:
Back Door Support
ComponentsCOMPONENTS ILLUSTRATION *1 BACK DOOR LOWER DAMPER STAY BRACKET LH *2 BACK DOOR STAY ASSEMBLY LH *3 BACK DOOR UPPER DAMPER STAY BRACKET LH - - N*m (kgf*cm, ft.*lbf
Back Door Weatherstrip
ComponentsCOMPONENTS ILLUSTRATION *1 BACK DOOR WEATHERSTRIP - - ● Non-reusable part - - RemovalREMOVAL PROCEDURE 1. REMOVE BACK DOOR WEATHERSTRIP (a) Remove the back door
SEE MORE:
Drive Motor "A" Inverter Performance (P0A78-286)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates a malfunction inside the inverter for the motor. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 3 Hybrid
High Voltage System Inter-Lock Circuit High (P0A0D-350,P0A0D-351)
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects that a safety device (interlock) is operated or that there is an open circuit in the detection circuit. (Even if an open circuit occurs while the vehicle is stopped, the system determines that the safety device was operated.)
