Lexus NX: Clearance Light Assembly (for Led Type Turn Signal Light)

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Clearance Light Assembly (for Led Type Turn Signal Light)

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH - -

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY (a) except Spo

 Inspection

INSPECTION PROCEDURE 1. INSPECT CLEARANCE LIGHT ASSEMBLY LH (a) Apply battery voltage to the connector and check the light illumination condition. OK: Battery Connection Specified Condition

SEE MORE:

 Open in Turn Signal Circuit (B1507,B1508)

DESCRIPTION These DTCs are stored when the combination meter assembly detects an open in a turn signal light circuit, a short in a turn signal light circuit, or a short in the hazard warning light circuit. DTC No. Detection Item DTC Detection Condition Trouble Area B1507 Open in Turn

 Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION This circuit is used when the voice switch of the steering pad switch assembly is pushed. Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER A

© 2016-2025 Copyright www.lexunx.com