Lexus NX: Installation

Lexus NX Service Manual / Vehicle Exterior / Mirror (ext) / Outer Mirror Control Ecu / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY

(a) Install the outer mirror control ECU assembly with the 2 screws.

(b) Connect the 2 connectors.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here

3. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Click here

4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Click here

5. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Click here

6. INSTALL FRONT DOOR TRIM COVER LH

Click here

SEE MORE:

Terminals Of Ecu

TERMINALS OF ECU CHECK MULTIPLEX NETWORK DOOR ECU (a) Disconnect the Y26 and Y27 multiplex network door ECU connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Terminal

Lost Communication with Image Processing Module "A" (U023A87)

DESCRIPTION The forward recognition camera is connected to the skid control ECU (brake booster with master cylinder assembly) via the CAN communication line. When the skid control ECU (brake booster with master cylinder assembly) receives a forward recognition camera communication malfunction signal

Lexus NX: Installation

READ NEXT:

Outer Mirror Switch

Components

Removal

SEE MORE:

Terminals Of Ecu

Lost Communication with Image Processing Module "A" (U023A87)