Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
Click here
.gif)
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 "TORX" screws.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
HINT:
A new power window regulator motor assembly LH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Click here
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
Click here
4. INSTALL FRONT DOOR GLASS RUN LH
Click here
5. INSTALL FRONT DOOR SERVICE HOLE COVER LH
Click here
6. INSTALL FRONT DOOR ARMREST SET BRACKET LH
Click here
7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
8. INSTALL FRONT DOOR TRIM COVER LH
Click here
9. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
Click here
10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
Click here
11. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
Click here
12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
13. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
14. INSTALL DECK FLOOR BOX LH
Click here
15. INSTALL REAR DECK FLOOR BOX
Click here
16. INSTALL DECK BOARD SUB-ASSEMBLY NO.3
Click here
17. CHECK SRS WARNING LIGHT
Click here
18. INITIALIZE POWER WINDOW CONTROL SYSTEM
Click here
19. CHECK POWER WINDOW CONTROL SYSTEM
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After the power switch is t
SEE MORE:
Reserve Lock Switch
ComponentsCOMPONENTS ILLUSTRATION *1 DOOR CONTROL SWITCH *2 PULL HANDLE RemovalREMOVAL PROCEDURE 1. REMOVE PULL HANDLE Click here 2. REMOVE DOOR CONTROL SWITCH (a) Detach the 2 claws and remove the door control switch. InspectionINSPECTION PROCEDURE 1. INSPECT DOOR C
Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of the portable player can be heard from the speakers. OK: Sound of the portable player can be heard from th
