Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | NEGATIVE AUXILIARY BATTERY TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | POWER WINDOW REGULATOR MOTOR ASSEMBLY LH | *2 | REAR DOOR ARMREST SET BRACKET LH |
| *3 | REAR DOOR GLASS RUN LH | *4 | REAR DOOR GLASS SUB-ASSEMBLY LH |
| *5 | REAR DOOR INSIDE HANDLE BEZEL PLUG LH | *6 | REAR DOOR REAR GUIDE SEAL LH |
| *7 | REAR DOOR SERVICE HOLE COVER LH | *8 | REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
| *9 | REAR DOOR TRIM COVER LH | *10 | REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH |
| *11 | REAR LOWER REAR DOOR WINDOW FRAME SUB-ASSEMBLY LH | *12 | REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
| *13 | HOLE PLUG | *14 | BUTYL TAPE |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
.png) | MP grease | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After the power switch is t
Inspection
INSPECTION PROCEDURE 1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH NOTICE:
Do not apply voltage to any terminals except terminals 1 and 2 to avoid damaging the pulse sensor inside the motor.
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the s
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, th
Components
COMPONENTS ILLUSTRATION *1 CRUISE CONTROL MAIN SWITCH - - N*m (kgf*cm, ft.*lbf): Specified torque - -
