Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL SEPARATE TYPE FRONT SEATBACK COVER LH
HINT:
-
When installing the seat cover, refer to the precautions in order to prevent wrinkles from forming.
Click here
.gif)
-
Align the seam allowance in a single direction as shown in the illustration.
.png)
(a) Using hog ring pliers, install the separate type front seatback cover LH to the separate type front seatback pad LH with 14 new hog rings in the order indicated in the illustration.
.png)
| *1 | Hog Ring Pliers |
NOTICE:
- Be careful not to damage the separate type front seatback cover.
- Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.
| (1) Pass the 3 seatback cover brackets through the 3 holes of the separate type front seatback pad. NOTICE: After the seatback cover bracket is installed, make sure the seatback cover bracket is not twisted. |
|
.png)
2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Click here
3. INSTALL FRONT SEAT HEADREST SUPPORT
Click here
4. INSTALL FRONT INNER SEAT CUSHION SHIELD LH
Click here
5. INSTALL FRONT SEAT CUSHION SHIELD LH
Click here
6. INSTALL FRONT LOWER SEAT CUSHION SHIELD
Click here
7. INSTALL FRONT SEAT ASSEMBLY LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT INNER SEAT CUSHION SHIELD LH *2 FRONT LOWER SEAT CUSHION SHIELD *3 FRONT SEAT CUSHION SHIELD LH *4 FRONT SEAT HEADREST SUPPORT *5 SEATBACK FE
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT LOWER SEAT CUS
SEE MORE:
Front Airbag Sensor Lost Communication (RH) (B1612,B1613)
DESCRIPTION The front airbag sensor RH circuit consists of the airbag ECU assembly and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbag should be deployed. DTC B1612 or B1613 is stored when a mal
Terminals Of Ecu
TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the I20 clearance warning ECU assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color Terminal Description C
