Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT LUMBAR POWER SEAT SWITCH
(a) Attach the 4 claws to install the front lumbar power seat switch.
2. INSTALL FRONT POWER SEAT SWITCH LH
Click here
3. INSTALL FRONT SEAT CUSHION SHIELD LH
Click here
4. INSTALL POWER SEAT SWITCH KNOB LH
Click here
5. INSTALL POWER SEAT SWITCH KNOB LH
Click here
6. INSTALL FRONT LOWER SEAT CUSHION SHIELD
Click here
7. INSTALL FRONT SEAT ASSEMBLY LH
Click here
READ NEXT:
COMPONENTS ILLUSTRATION *1 FRONT LOWER SEAT CUSHION SHIELD *2 FRONT POWER SEAT SWITCH LH *3 FRONT SEAT CUSHION SHIELD LH *4 POWER SEAT SWITCH KNOB LH *5 POWER SEAT SWITCH KNO
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2.
SEE MORE:
DESCRIPTION When the engine is idling stably under a low load, if the idle speed drops or becomes unstable, this DTC will be stored. Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troublesho
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main
© 2016-2024 Copyright www.lexunx.com