Lexus NX: Steering Pad

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau

 Installation

INSTALLATION PROCEDURE 1. INSTALL STEERING PAD ASSEMBLY (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal. CAUTION: Wait

SEE MORE:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for RHD and LHD vehicles. The procedure listed below is for LHD vehicles. PROCEDURE 1. INSTALL COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) (a) Connect the aspirator hose. (b) Connect the connector. (c) Attach the 2 claws to in

 Removal

REMOVAL PROCEDURE 1. REMOVE FAN SHROUD WITH COOLING FAN Click here 2. REMOVE COOLING FAN WIRE (a) Disconnect the cooling fan ECU connector. (b) Detach the 3 clamps and remove the cooling fan wire. 3. REMOVE COOLING FAN ECU (a) Disconnect the cooling fan motor connector and No. 2

© 2016-2026 Copyright www.lexunx.com