Lexus NX manuals

Lexus NX: Initialization

Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System / Initialization

INITIALIZATION

INITIALIZE PANORAMIC VIEW MONITOR SYSTEM

(a) When "!" mark is displayed on the multi-display assembly, correct the steering angle neutral point using the following method.

(1) Fully turn the steering wheel to the left and right on flat ground.

NOTICE:

Memorizing the steering angle neutral point must be carried out with the power switch on (READY). Apply the parking brake, depress the brake pedal, check that the shift lever is in P, and ensure that the vehicle is not moving.

HINT:

If the steering angle neutral point cannot be memorized by fully turning the steering wheel to the left and right perform Steering Angle Setting in Calibration.

Click here

READ NEXT:

 Calibration

CALIBRATION ADJUST PANORAMIC VIEW MONITOR SYSTEM (a) This panoramic view monitor system can be set from the diagnostic screen of the multi-display assembly. (b) If the following operations are perform

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: The following inspection procedure of the panoramic view monitor system is described on the assumption that the audio and visual system*1 or navigation system*2 is no

 Terminals Of Ecu

TERMINALS OF ECU PARKING ASSIST ECU (a) Disconnect the P44 parking assist ECU connector. (b) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol)

SEE MORE:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 ENGINE ROOM RELAY BLOCK - AM2 FUSE - - ILLUSTRATION *A w/o Power Back Door System *B w/ Power Back Door System *1 BACK DOOR LOCK ASSEMBLY *2 BACK DOOR LOCK ASSEMBLY *3 BACK DOOR OPENER SWITCH ASSEMBLY *4 FRONT DOOR COURT

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (DYNAMIC RADAR CRUISE CONTROL SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (

© 2016-2026 Copyright www.lexunx.com