Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY
NOTICE:
Do not reuse dropped or damaged parts.
(a) Connect the connector.
(b) Attach the clamp to install the No. 3 indoor electrical key antenna assembly.
2. INSTALL NO. 2 TOOL BOX SUB-ASSEMBLY
Click here .gif)
3. INSTALL NO. 1 TOOL BOX SUB-ASSEMBLY
Click here
4. INSTALL DECK FLOOR BOX LH
Click here
5. INSTALL DECK FLOOR BOX RH
Click here
6. INSTALL NO. 1 SPARE WHEEL CARRIER
7. INSTALL SPARE TIRE
Click here
8. INSTALL REAR DECK FLOOR BOX
Click here
9. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
Click here
10. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
11. INSTALL DECK BOARD ASSEMBLY
Click here
12. INSTALL TONNEAU COVER ASSEMBLY
Click here
13. INSTALL REAR SEAT ASSEMBLY (for Manual Seat)
Click here
14. INSTALL REAR SEAT ASSEMBLY (for Power Seat)
Click here
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (for Power Seat) Click here 2. REMOVE REAR SEAT ASSEMBLY (for Manual Seat) Click here 3. REMOVE TONNEAU COVER ASSEMBLY Click here 4. REMOVE DE
Components
COMPONENTS ILLUSTRATION *1 ELECTRICAL KEY ANTENNA *2 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH *3 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH *4 REAR BUMPER COVER *5 REAR FLOOR S
SEE MORE:
EVAP System
RELATED DTCS DTC No. Monitoring Item Link P00FE EVAP vent line blocked P043E Reference orifice clogged (built into canister pump module) P043F Reference orifice high-flow (built into canister pump module) P0441
Purge VSV (Vacuum Switching Valve) stuck clos
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect
