Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | ELECTRICAL KEY ANTENNA | *2 | QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH |
| *3 | QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH | *4 | REAR BUMPER COVER |
| *5 | REAR FLOOR SIDE MEMBER COVER | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH Click here 2. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH Click here 3. REMOVE REAR FLOOR SIDE MEMBER COVER Click here
Installation
INSTALLATION PROCEDURE 1. INSTALL ELECTRICAL KEY ANTENNA NOTICE: Do not reuse dropped or damaged parts. (a) Attach the guide and install the electrical key antenna with the nut. Torque: 7.5 N·m {76
Electrical Key Oscillator(for Rear Floor)
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 2 CONSOLE BOX MOUNTING BRACKET *2 NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREM
SEE MORE:
Daytime Running Light Relay Circuit
DESCRIPTION The illumination of the daytime running light (clearance light assembly) or clearance light is controlled by the headlight light control ECU sub-assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following
Generator Control Module (P0A1A-658,P0A1A-791,P1C2A-155,P1CA6-156,P3133-659)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detection Item DTC Detection Co
© 2016-2026 Copyright www.lexunx.com
