Lexus NX: Installation
Lexus NX Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Intrusion Sensor / Installation
INSTALLATION
PROCEDURE
1. INSTALL THEFT WARNING ULTRASONIC SENSOR
(a) Attach the 4 clamps to install the theft warning ultrasonic sensor.
(b) Install the 6 screws and connect the connector.
2. INSTALL MAP LIGHT ASSEMBLY
Click here .gif)
3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
5. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)
Click here
6. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)
Click here
7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
8. INSTALL DECK BOARD ASSEMBLY
Click here
READ NEXT:
Security Horn Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 SECURITY HORN ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE SECURITY HORN ASSEMBLY (a) R
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 NO. 2 DECK BOARD SUB-ASSEMBLY *3 NO. 3 DECK BOARD SUB-ASSEMBLY - - ILLU
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH. Click here HINT:
Use the table below to help determine the cause of problem symptoms. If multiple susp
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK/CLEAR (a) Check for DTCs. (1) Connect the Techstream to the DLC3. (2) Turn the power switch on (IG). (3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes. Chassis &g
© 2016-2026 Copyright www.lexunx.com
