Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY
(a) Install the remote operation controller assembly with the 4 bolts.
2. INSTALL UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
Click here .gif)
3. INSTALL UPPER REAR CONSOLE PANEL
Click here
4. INSTALL CONSOLE ARMREST ASSEMBLY
Click here
5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Click here
6. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
Click here
7. INSTALL NO. 2 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
8. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Click here
9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
10. INSTALL NO. 1 SWITCH HOLE BASE
Click here
11. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
12. INSTALL INSTRUMENT SIDE PANEL LH
Click here
13. INSTALL INSTRUMENT SIDE PANEL RH
Click here
14. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH
Click here
15. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH
Click here
16. INSTALL MULTI-DISPLAY ASSEMBLY WITH BRACKET
Click here
17. INSTALL INSTRUMENT PANEL FINISH PLATE
Click here
18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
19. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
20. CHECK SRS WARNING LIGHT
Click here
21. INSTALL DECK FLOOR BOX LH
Click here
22. INSTALL REAR DECK FLOOR BOX
Click here
23. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
24. INSTALL DECK BOARD ASSEMBLY
Click here
READ NEXT:
Telephone Microphone Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 TELEPHONE MICROPHONE ASSEMBLY - -
Blind Spot Monitor Main Switch
InspectionINSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH ASSEMBLY (BLIND SPOT MONITOR MAIN SWITCH) (a) Remove the combination switch assembly. Click here (b) Measure the resistance according
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 5 (S) - 1 (GND) EV mode switch pushed and held Below 10 Ω
Installation
INSTALLATION PROCEDURE 1. INSTALL ULTRASONIC SENSOR CUSHION SET HINT: Perform the following procedure only when replacement of a ultrasonic sensor cushion set is necessary. (a) Install the ultrasonic sensor cushion set as shown in the illustration. Install in this Direction - - 2. INST
