Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR TELEVISION CAMERA ASSEMBLY
(a) Install the 2 screws and rear television camera assembly.
(b) Connect the connector.
2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here
4. INSTALL BACK DOOR SIDE GARNISH LH
Click here
5. INSTALL BACK DOOR SIDE GARNISH RH
Click here
6. INSTALL BACK DOOR CENTER GARNISH
Click here
7. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
8. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
9. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
10. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
11. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
12. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
13. ADJUST REAR TELEVISION CAMERA ASSEMBLY
(a) w/ Parking Assist Monitor System:
Click here
(b) w/ Panoramic View Monitor System:
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT DOOR INSIDE HANDLE BEZEL PLUG LH *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH *3 FRONT DOOR TRIM COVER LH *4 OUTER MIRROR INSTALL HOLE COVER LH *5
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION Click here 2. REMOVE FRONT DOOR T
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the T9 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. Tester Connection Wiring Color Terminal
Hybrid Battery System Discharge Time Too Long (P0C76-523)
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects that the electrical charge stored in the high-voltage condenser of the inverter with converter assembly cannot be discharged. The cause of this malfunction may be one of the following: Inside of inverter voltage sensor (VH)
