Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY LH
(a) Install the side television camera assembly LH with the 2 screws.
2. INSTALL LOWER OUTER MIRROR COVER LH
Click here .gif)
3. INSTALL OUTER MIRROR BEZEL LH
Click here
4. INSTALL OUTER MIRROR COVER LH
Click here
5. INSTALL OUTER MIRROR LH
Click here
6. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
Click here
7. INSTALL OUTER MIRROR INSTALL HOLE COVER LH
Click here
8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here
9. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
Click here
10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
Click here
11. INSTALL FRONT DOOR TRIM COVER LH
Click here
12. ADJUST SIDE TELEVISION CAMERA ASSEMBLY LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A except Sport Package - - *1 FRONT CENTER ULTRASONIC SENSOR *2 FRONT CORNER ULTRASONIC SENSOR *3 FRONT CORNER ULTRASONIC SENSOR RETAINER *4 NO.
Removal
REMOVAL PROCEDURE 1. PRECAUTION Click here 2. REMOVE FRONT BUMPER COVER (a) for Sport Pacakge: Click here (b) except Sport Pacakge: Click here 3. REMOVE NO. 3 ENGINE ROOM WIRE (a) for Sport Paca
SEE MORE:
System Description
SYSTEM DESCRIPTION REAR POWER SEAT CONTROL SYSTEM DESCRIPTION
This system has the following functions: reclining, folding and return, and jam protection.
Both the left and right seats are equipped with this system. Each system operates independently.
FUNCTIONS OF MAIN COMPONENTS Component
System Diagram
SYSTEM DIAGRAM Communication Table Transmitting ECU (Transmitter) Receiving ECU Signal Communication Method Main Body ECU (Multiplex Network Body ECU) Multiplex Tilt and Telescopic ECU
Auto away/return state signal
3Tilt and telescopic position request signal
Driver positio
