Lexus NX: Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)

Lexus NX Service Manual / Audio & Visual & Telematics / Telematics / Telematics System / Lost Communication with Body Control Module Missing Message (U014087,U015587,U016387)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the CAN communication circuit.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U014087

Lost Communication with Body Control Module Missing Message

CAN reception error

CAN communication system

U015587

Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message

CAN reception error

CAN communication system

U016387

Lost Communication with Navigation Control Module Missing Message

CAN reception error

CAN communication system

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Click here

Body Electrical > Telematics > Clear DTCs

(b) Recheck for DTCs and check if the same DTCs are output again.

Click here

Body Electrical > Telematics > Trouble Codes

Result

Proceed to

No DTCs are output.

A

DTCs are output.

B

A

USE SIMULATION METHOD TO CHECK

B

GO TO CAN COMMUNICATION SYSTEM

READ NEXT:

 Remote Engine Starter does not Operate

WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Before replacing the certification ECU (smart key ECU assembly), refer to smart access system with push-button start (for Entry Function) Precaution. Cl

 Remote Service Malfunction

PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Bus Check. Cl

 Warning Notification Function Malfunction

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH LH (w/o Memory) (a) Measure the resistance according to the value(s) in the tables below. Standard Resistance (Slide Switch): Tester Connection Switch Condition Specified Condition 5 (SLDF) - 8 (B) 5 (SLDF) - 7 (B1) Front posit

 Control Module Communication Bus "A" Off (U0073,U0100,U0101,U0126,U0129,U0142,U0155,U0293)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Control Module Communication Bus "A" Off Bus off condition is detected. CAN communication system U0100 Lost Communication with ECM / PCM "A" Communication stop occurs between the headlight ECU su

© 2016-2026 Copyright www.lexunx.com