Lexus NX manuals

Lexus NX: Lost Communication with Clock Device (Local-CAN) (B1326)

Lexus NX Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Lost Communication with Clock Device (Local-CAN) (B1326)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Memory

B1326

Lost Communication with Clock Device (Local-CAN)

After the radio receiver assembly receives a registration information signal, which is sent by the clock assembly when the power switch is turned on (IG), 1 or more times, the radio receiver assembly does not receive the signal for 30 seconds or more
  • Local bus communication line
  • Clock assembly power source circuit
  • Clock assembly
  • Radio receiver assembly
  • Harness or connector
  • No. 4 CAN junction connector

DTC stored

CAUTION / NOTICE / HINT

HINT:

B1326 will not continue to output when clear DTC is performed even if the malfunction continues.

PROCEDURE

1.

CHECK FOR DTC

(a) Check if meter / gauge system DTCs are output.

Click here

Body Electrical > Combination Meter > Trouble Codes

Result

Proceed to

DTC B1326 is not output.

A

DTC B1326 is output.

B
A

USE SIMULATION METHOD TO CHECK

B

GO TO NAVIGATION SYSTEM

READ NEXT:

 Fuel Sender Open Detected (B1500)

DESCRIPTION This DTC is stored when the combination meter detects a fuel sender gauge malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area B1500 Fuel Sender Open Det

 Open in Turn Signal Circuit (B1507,B1508)

DESCRIPTION These DTCs are stored when the combination meter assembly detects an open in a turn signal light circuit, a short in a turn signal light circuit, or a short in the hazard warning light cir

 Lost Communication with EV ECU (U0100,U0129,U0131,U0142,U0151,U0163,U0182,U023A)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U0100 Lost Communication with EV ECU Both conditions are met: IG voltage is 10.5 V or higher. No communica

SEE MORE:

 Cold Start Idle Air Control System Performance (P050A)

MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the eng

 Removal

REMOVAL PROCEDURE 1. PRECAUTION CAUTION: The hybrid system has high-voltage circuits. Accidents, such as electric shock, or electric leaks may result if the hybrid system is not operated in a correct manner. Make sure to follow the correct procedure. Click here NOTICE: After turning the power swit

© 2016-2026 Copyright www.lexunx.com