Lexus NX: Lost Communication with Main Body ECU (U0142,U0208)
Lexus NX Service Manual / Steering / Steering Column / Power Tilt And Power Telescopic Steering Column System / Lost Communication with Main Body ECU (U0142,U0208)
DESCRIPTION
The multiplex tilt and telescopic ECU receives signals from the main body ECU (multiplex network body ECU) and front power seat switch via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0142 | Lost Communication with Main Body ECU | Lost communication with main body ECU (multiplex network body ECU) |
|
| U0208 | Lost Communication with "Seat Control Module A" | Lost communication with front power seat switch |
|
PROCEDURE
| 1. | GO TO CAN COMMUNICATION SYSTEM |
(a) Go to CAN Communication System.
Click here .gif)
| NEXT | .gif) | END |
READ NEXT:
Actuator Power Source Circuit
DESCRIPTION This is the power source for the power tilt and power telescopic steering column system. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this syst
Tilt and Telescopic Manual Switch Circuit
DESCRIPTION Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in
IG Power Source Circuit
DESCRIPTION When the power switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU. The multiplex tilt and telescopic ECU also rece
SEE MORE:
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Indicator Circuit
DESCRIPTION In accordance with the shift lever position, each shift position indicator light will turn on. WIRING DIAGRAM PROCEDURE 1. CHECK SHIFT POSITION INDICATOR (a) Turn the power switch on (ACC). (b) Check that each shift position indicator light turns on correctly. Result Proce
© 2016-2025 Copyright www.lexunx.com
