Lexus NX: Motor Water Jacket Cover Assembly

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY - - ILLUSTRATION *1 FRONT ENGINE MOUNTING BRACKET *2 HYBRID VEHICLE TRANSAXLE ASSEMBLY *3 NO. 1 MOTOR WATER JA

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN COOLANT (for Inverter Coolant) Click here 3. REMOVE NO. 2 MOTOR WATER JACKET COVER ASSEMBLY (a) Remove the 5

 Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 3 MOTOR WATER JACKET COVER ASSEMBLY (a) Remove any remaining seal packing from the transaxle housing installation surface and bolt holes. NOTICE: Clean and deg

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *A w/o AVS - - *1 REAR NO. 1 SHOCK ABSORBER BRACKET LH *2 REAR SHOCK ABSORBER ASSEMBLY LH *3 REAR SUSPENSION ARM COVER LH -   N*m (kgf*cm, ft.*lbf): Specified torque * For use with ball joint lock nut wrench ILLUSTRATION *A

 Relay

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT LIGHT CUT RELAY (a) Remove the upper instrument panel sub-assembly. Click here (b) Remove the light cut relay. (c) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Sta

© 2016-2026 Copyright www.lexunx.com