Lexus NX manuals

Lexus NX: No Sound can be Heard from Speakers

Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System / No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Sound Quality is Bad Only when Disc is Played (Volume is Too Low)

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Disc cannot be Inserted or is Ejected Right After Insertion

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Disc cannot be Ejected

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 4 claws and 3 guide pins to install the steering pad switch assembly to the steering wheel sub-assembly. (b) Install the 2 screws. (c) Connect the steering pad switch connector to the No. 1 switch wire. (d) Connect the ste

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (a) Install the lower No. 2 instrument panel finish panel with the 4 screws. 2. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH (a) Attach the 2 clips to install the No. 2 instrument cluster finish pane

© 2016-2026 Copyright www.lexunx.com