Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY
HINT:
Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3 with the power switch off.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Electric Parking Brake / Active Test
(e) When the vehicle's tires are lifted off the ground and the Techstream is used to operate the electric parking brake, check the condition of the rear tires.
(f) According to the display on the tester, perform the Active Test.
Chassis > Electric Parking Brake > Active Test| Tester Display |
|---|
| PKB Release1 |
| Tester Display |
|---|
| PKB Lock1 |
If the result is not as specified, inspect the electric parking brake actuator.
Click here .gif)
(g) Turn the power switch on (IG), push the electric parking brake switch to the lock side for 1 second and check that the parking brake indicator light (red) illuminates.
(h) Also, check that the brake warning light / yellow (minor malfunction) does not illuminate at this time.
READ NEXT:
Removal
REMOVAL PROCEDURE 1. RELEASE PARKING BRAKE (a) With the power switch on (IG), operate the electric parking brake switch to release the parking brake. Then turn the power switch off. HINT: If the parki
Inspection
INSPECTION PROCEDURE 1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) Parking brake actuator assembly operation inspection (1) Apply voltage to the terminals of the parking brake actuator assembly an
Installation
INSTALLATION PROCEDURE 1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY LH (a) Apply a light coat of lithium soap base glycol grease to the new O-ring. (b) Install the O-ring to the rear disc brake cylinder
SEE MORE:
Vehicle Speed Signal (C1541)
DESCRIPTION The power steering ECU assembly receives vehicle speed signals from the skid control ECU via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed based on the signals. DTC No. Detection Item DTC Detection Condition Trouble Area W
Installation
INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (SEAT BELT WARNING LIGHT) (a) Connect the 2 connectors. (b) Attach the 6 clips to install the air conditioning control assembly (seat belt warning light). NOTICE: Do not touch the switch, display or clock parts. 2. IN
