Lexus NX manuals

Lexus NX: Operation Check

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Afs (adaptive Front-lighting System) / Operation Check

OPERATION CHECK

AFS (FRONT-LIGHTING ADAPTIVE SYSTEM) OPERATION CHECK

NOTICE:

Make sure that the customize settings are set to default when performing the AFS (front-lighting adaptive system) operation check.

(a) Perform the following operation with the low beam headlights on and check that the headlight ECU sub-assembly LH performs low speed control of the AFS (front-lighting adaptive system):

  • Drive the vehicle at a speed between 10 km/h (6 mph) and 30 km/h (19 mph) and turn the steering wheel 27° or more.

(b) Perform the following operation with the low beam headlights on and check that the headlight ECU sub-assembly LH performs medium-to-high speed control of the AFS (front-lighting adaptive system):

  • Drive the vehicle at a speed of 30 km/h (19 mph) or more and turn the steering wheel 7.5 degrees or more.

(c) Perform any of the following operations and check that the headlight ECU sub-assembly LH cancels control of the AFS (front-lighting adaptive system):

  • The power switch not on (READY).
  • Turn the low beam headlights off.
  • Decrease the vehicle speed to less than 5 km/h (3 mph).
  • Reduce the steering angle to less than 6 degrees.
  • Move the shift lever to N or R.

READ NEXT:

 Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make

 Initialization

INITIALIZATION NOTICE: The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH. Click he

SEE MORE:

 Voice Guidance does not Function

WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur: A communication malfunction DTC m

 Room Oscillator does not Recognize Key

DESCRIPTION If code verification cannot be performed in the vehicle interior, there may be problems with the communication between the vehicle (No. 1 indoor electrical key antenna assembly (front floor), No. 2 indoor electrical key antenna assembly (rear floor) or No. 3 indoor electrical key antenna

© 2016-2026 Copyright www.lexunx.com