Lexus NX: Operation Check
Lexus NX Service Manual / Vehicle Exterior / Window / Glass / Windshield Deicer System / Operation Check
OPERATION CHECK
CHECK WINDSHIELD DEICER SYSTEM
(a) Turn the power switch on (IG).
(b) Check that the windshield deicer becomes warm by operating the windshield deicer switch of the multi-display assembly.
(c) When the vehicle is stopped, confirm that the windshield deicer stops after approximately 15 minutes.
NOTICE:
If the auxiliary battery voltage becomes low, windshield deicer operation is canceled to prioritize supplying power to the power steering system.
for Power Tilt and Power Telescopic Steering Column: Click here .gif)
for Manual Tilt and Manual Telescopic Steering Column: Click here
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the auxiliary battery voltage becomes low, windshield deicer operation is canceled to prioritize supplying power to the power steering system. for Power Tilt and Powe
Terminals Of Ecu
TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the I50 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in th
Data List / Active Test
DATA LIST / ACTIVE TEST ACTIVE TEST HINT: Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive func
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 HEADLIGHT ASSEMBLY LH - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A w/ Headlight ECU - - *1 FRONT SIDE MAKER LIGHT BULB *2 FRONT SIDE MARKER LIGHT SOCKET *3 HEADLIGHT ECU SUB-ASSEMBLY LH *4 HEADLIGHT G
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL FRONT SKID CONTROL SENSOR WIRE LH (w/ AVS) (a) Install the sensor clamp as follows. (1) Install the grommet to the absorber brack
© 2016-2026 Copyright www.lexunx.com
