Lexus NX: Data List / Active Test
DATA LIST / ACTIVE TEST
ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Active Test.
(e) According to the display on the Techstream, perform the Active Test.
Body Electrical > Air Conditioner > Active Test| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Deicer Relay (Front) | Windshield glass (windshield deicer wire) | OFF or ON | - |
READ NEXT:
Windshield Deicer does not Operate
DESCRIPTION When the windshield deicer switch is operated, the operation signal is transmitted to the radio receiver assembly. The radio receiver assembly transmits the operation signal to the air con
Components
COMPONENTS ILLUSTRATION *1 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *2 FRONT FENDER TO COWL SIDE SEAL LH *3 FRONT FENDER TO COWL SIDE SEAL RH *4 FRONT WIPER ARM HEAD CAP *5 FR
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE 1. INSTALL COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) (a) Connect the aspirator hose. (b) Connect the connector. (c) Attach the 2 claws to in
If your vehicle overheats
The following may indicate that
your vehicle is overheating.
The needle of the engine coolant
temperature gauge
enters the red zone, or a loss of
hybrid system power is experienced.
(For example, the vehicle
speed does not increase.)
"Engine Coolant Temp High" or
"Hybrid System Ov
