Lexus NX: Precaution
PRECAUTION
NOTICE:
When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST:Desktop antistatic mat set (09890-47010)
-
Wristband
SST:
09891-04020
-
Wristband connection wire (No. 1 grounding wire)
SST:
09891-04030
-
Antistatic mat
SST:
09891-04010
-
Ground connection wire (No. 2 grounding wire)
SST:
09891-04040
.png)
PRECAUTIONS DURING REPLACEMENT
(a) Precautions during procedures:
(1) Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
(2) To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.
(3) Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
(4) When performing procedures, do not allow clothing to come near or contact parts.
(b) Wear the SST (wristband) firmly on your wrist.
SST:
09891-04020
(c) Connect the SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.
SST:
09891-04040
09891-04010
HINT:
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
.png)
(d) Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).
SST:
09891-04030
(e) Always place the headlight assembly and its components on SST (antistatic mat).
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Single Beam Headlight - - *1 HEADLIGHT ASSEMBLY LH *2 HEADLIGHT ECU SUB-ASSEMBLY LH *3 HEADLIGHT GASKET - - ● Non-reusable part -
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Handle components indoors as much as possible to prevent foreign matter from entering
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.
Do not reuse part
SEE MORE:
Right Headlight ECU Variation Error (B2455)
DESCRIPTION This DTC is output when a headlight ECU sub-assembly RH that is incompatible with the vehicle is installed. The headlight ECU sub-assembly LH outputs DTC B2455. DTC No. Detection Item DTC Detection Condition Trouble Area B2455 Right Headlight ECU Variation Error Headligh
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, th
