Lexus NX: Headlight Ecu
READ NEXT:
Precaution
PRECAUTION NOTICE: When disassembling the headlight assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by ele
Components
COMPONENTS ILLUSTRATION *A for Single Beam Headlight - - *1 HEADLIGHT ASSEMBLY LH *2 HEADLIGHT ECU SUB-ASSEMBLY LH *3 HEADLIGHT GASKET - - ● Non-reusable part -
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Handle components indoors as much as possible to prevent foreign matter from entering
SEE MORE:
Absorber Control Actuator (for Front Side)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ABSORBER CONTROL ACTUATOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for LH Side Tester Connection Condition Specified Condition 1 (FAL-) - 2 (FAL+) 15 to 25°C 2.8
Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)
DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (
© 2016-2026 Copyright www.lexunx.com
