Lexus NX: Precaution
PRECAUTION
PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
(a) If even a thin film of oil is left on the surface of a headlight bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand does not contact the glass part of the light.
(b) As the internal pressure of headlight bulbs is high, dropping, hitting or damaging a bulb may result in it exploding and shattering.
(c) Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
(d) Always replace a bulb with another bulb of the same wattage.
(e) If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
(f) Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if the socket is not installed securely.
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 SHIFT LEVER POSITION SENSOR *3 SIDE TURN SIGNAL LIGHT ASSEMBLY LH *4 SIDE TURN SIGNAL LIGHT ASSEMBLY
System Diagram
SYSTEM DIAGRAM Tail, Stop, Headlight Circuit Turn Signal Circuit
System Description
SYSTEM DESCRIPTION AUTOMATIC LIGHT CONTROL SYSTEM (a) When the headlight dimmer switch is in the AUTO position, the automatic light control system detects ambient light levels and controls the headlig
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 FOLD SEAT SWITCH ASSEMBLY (for Rear Side) (a) Connect the connector. (b) Attach the 2 claws to install the No. 2 fold seat switch assembly. 2. INSTALL REAR POWER SEAT SWITCH (for Rear Seat) HINT: Use the same procedure for both re
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).
Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the
