Lexus NX: Lighting System (for Single Beam Headlight)
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System (for Single Beam Headlight)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Light Sensor Circuit Malfunction (B1244)
- LED Headlight LH Circuit Malfunction (B2430,B2431)
- Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012987,U014087,U029387)
- Lost Communication with Cruise Control Front Distance Range Sensor Missing Message (U023587)
- Turn Signal Switch Circuit
- Headlight Dimmer Switch Circuit
- Daytime Running Light Relay Circuit
- Front Fog Light Circuit
- Hazard Warning Switch Circuit
- Taillight Relay Circuit
- Low Beam Headlight Circuit
- High Beam Headlight Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR HEADLIGHT BULB REPLACEMENT (a) If even a thin film of oil is left on the surface of a headlight bulb, its service life will be shortened because the light will burn at a high
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 SHIFT LEVER POSITION SENSOR *3 SIDE TURN SIGNAL LIGHT ASSEMBLY LH *4 SIDE TURN SIGNAL LIGHT ASSEMBLY
System Diagram
SYSTEM DIAGRAM Tail, Stop, Headlight Circuit Turn Signal Circuit
SEE MORE:
Front Passenger Side Power Window Switch
ComponentsCOMPONENTS ILLUSTRATION *1 POWER WINDOW REGULATOR SWITCH ASSEMBLY *2 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL *3 FRONT DOOR ARMREST BASE PANEL - - RemovalREMOVAL PROCEDURE 1. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT
Installation
INSTALLATION PROCEDURE 1. INSTALL THEFT WARNING ULTRASONIC SENSOR (a) Attach the 4 clamps to install the theft warning ultrasonic sensor. (b) Install the 6 screws and connect the connector. 2. INSTALL MAP LIGHT ASSEMBLY Click here 3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 4. INITIALI
© 2016-2026 Copyright www.lexunx.com
