Lexus NX: Precaution
PRECAUTION
NOTICE:
When disassembling the rear combination light assembly, use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).
STATIC ELECTRICITY COUNTERMEASURES SST
SST:Desktop antistatic mat set (09890-47010)
-
Wristband
SST:
09891-04020
-
Wristband connection wire (No. 1 grounding wire)
SST:
09891-04030
-
Antistatic mat
SST:
09891-04010
-
Ground connection wire (No. 2 grounding wire)
SST:
09891-04040
.png)
PRECAUTIONS DURING REPLACEMENT
(a) Precautions during procedures:
(1) Before performing any procedures, touch an unpainted metal part or ground bolt of the vehicle to eliminate any static electricity.
(2) To prevent damage to electrical equipment, disconnect the battery power supply before installing and removing electrical equipment.
(3) Never touch the electronic parts of a printed wire board or the pins of an integrated circuit.
(4) When performing procedures, do not allow clothing to come near or contact parts.
(b) Wear the SST (wristband) firmly on your wrist.
SST:
09891-04020
(c) Connect the SST (No. 2 grounding wire) and SST (antistatic mat) to an appropriate grounding point in the workspace and on the work table.
SST:
09891-04040
09891-04010
HINT:
When working inside the vehicle:
Connect SST (No. 2 grounding wire) to the unpainted metal part of a grounded bolt, etc.
.png)
(d) Connect SST (No. 1 grounding wire), SST (wristband) and SST (antistatic mat).
SST:
09891-04030
(e) Always place the rear combination light assembly and its components on SST (antistatic mat).
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 DECK FLOOR BOX LH *3 DECK FLOOR BOX RH *4 NO. 2 DECK BOARD SUB-ASSEMBLY
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY Click here 2.
Disassembly
DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Handle components indoors as much as possible to prevent foreign matter from enter
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY Click here 2. REMOVE BACK DOOR CENTER GARNISH Click here 3. REMOVE BACK DOOR SIDE GARNISH LH Click here 4. REMOVE BACK DOOR SIDE GARNISH RH Click here 5. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door) Click here 6. REMOVE PULL HA
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the batte
