Lexus NX: Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
GENERAL PRECAUTION
Perform zero point calibration and sensitivity check if any of the following conditions occur:
-
The occupant detection ECU is replaced.
-
Accessories (seatback tray and seat cover, etc.) are installed.
-
The front passenger seat is removed from the vehicle.
-
One of the bolts that is used to install the front passenger seat is removed and reinstalled.
-
An occupant classification sensor collision detection DTC is output due to an accident or a collision.
READ NEXT:
PARTS LOCATION ILLUSTRATION *1 NO. 2 ENGINE ROOM RELAY BLOCK - ODS FUSE *2 FRONT SEAT INNER BELT ASSEMBLY RH *3 AIR CONDITIONING CONTROL ASSEMBLY *4 OCCUPANT DETECTION ECU *5
SYSTEM DESCRIPTION GENERAL (a) In the occupant classification system, the occupant detection ECU calculates the weight of the occupant based on signals from the occupant classification sensors. This s
SEE MORE:
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precoution thoroughly before serving. Click here NOTICE: After turning the power switch off, there may b
For comfortable cabin experience,
the ceiling (moon roof) can be
opened or tilted up.
WARNING
■Opening the moon roof
Observe the following precautions.
Failure to do so may cause death or serious
injury.
Do not allow any passengers to put
their hands or heads outside the vehicle
w
© 2016-2026 Copyright www.lexunx.com
