Lexus NX: System Diagram

SYSTEM DIAGRAM

READ NEXT:

 System Description

SYSTEM DESCRIPTION GENERAL (a) In the occupant classification system, the occupant detection ECU calculates the weight of the occupant based on signals from the occupant classification sensors. This s

 How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the occupant classification system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEX

 Initialization

INITIALIZATION NOTICE: Make sure that the front passenger seat is not occupied before performing the operation. HINT: Perform zero point calibration and sensitivity check if any of the following cond

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL BATTERY COOLING BLOWER ASSEMBLY LH CAUTION: Wear insulated gloves and use insulated tools. (a) Install the battery cooling blower assembly LH with the 3 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} (b) Connect the wire harness clamp and connector. 2. INSTALL BAT

 Rear Center Seat Outer Belt Assembly

ComponentsCOMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 SEAT BELT ANCHOR COVER N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE SEAT BELT ANCHOR COVER (a) Using moulding remover D, detach the 2 claws. (b) Det

© 2016-2024 Copyright www.lexunx.com