Lexus NX: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Front Suspension System| Symptom | Suspected Area | Link |
|---|---|---|
| Vehicle unstable | Tires (Worn or improperly inflated) | |
| Front wheel alignment | | |
| Rear wheel alignment | | |
| Front hub bearing | | |
| Rear hub bearing | | |
| Front shock absorber with coil spring | | |
| Rear shock absorber | | |
| Rear coil spring | | |
| Bottoming | Vehicle (Overloaded) | - |
| Front shock absorber with coil spring | | |
| Rear shock absorber | | |
| Rear coil spring | | |
| Swaying/pitching | Tires (Worn or improperly inflated) | |
| Front stabilizer bar | | |
| Front shock absorber with coil spring | | |
| Rear shock absorber | | |
| Rear coil spring | | |
| Front wheel shimmy | Tires (Worn or improperly inflated) | |
| Wheels (Out of balance) | | |
| Front wheel alignment | | |
| Front suspension lower arm | | |
| Front lower ball joint | | |
| Front shock absorber with coil spring | | |
| Front hub bearing | | |
| Abnormal tire wear | Tires (Worn or improperly inflated) | |
| Wheels (Out of balance) | | |
| Front wheel alignment | | |
| Rear wheel alignment | | |
| Vehicle pull | Tires (Worn or improperly inflated) | |
| Front wheel alignment | | |
| Rear wheel alignment | | |
| Brake (Dragging) | | |
| Steering wheel (Off center) | |
.gif)
READ NEXT:
Performance Damper
ComponentsCOMPONENTS ILLUSTRATION *1 SUSPENSION TOWER DAMPER - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBL
Performance Rod
ComponentsCOMPONENTS ILLUSTRATION *1 SUSPENSION TOWER DAMPER - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBL
SEE MORE:
Ignition Hold Monitor Malfunction (B2271)
DESCRIPTION This DTC is stored when a malfunction in the IG circuit and IG hold circuit in the certification ECU (smart key ECU assembly) is detected. DTC No. Detection Item DTC Detection Condition Trouble Area Note B2271 Ignition Hold Monitor Malfunction When either of the follow
Lost Communication with Tilt & (U1115)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U1115 Lost Communication with Tilt & Telescopic Module There is no communication from the multiplex tilt and telescopic ECU.
Power source circuit of multiplex tilt and telescopic ECU
