Lexus NX: Front Suspension
Lexus NX Service Manual / Suspension / Front Suspension
- Front Lower Ball Joint
- Front Lower Suspension Arm
- Front Shock Absorber
- Front Stabilizer Bar
- Front Suspension Member
- Front Suspension System
- Performance Damper
- Performance Rod
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT AXLE ASSEMBLY LH *2 FRONT LOWER BALL JOINT ASSEMBLY LH *3 CLIP - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY LH (a) Jack up the vehicle. (b) Move the front lower suspension arm up and down by hand and check for rattle. OK: No rattle
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 DOOR SCUFF PLATE ASSEMBLY LH
Cold Start Idle Air Control System Performance (P050A)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC will be stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the idle air control at cold start. When the eng
© 2016-2026 Copyright www.lexunx.com
