Lexus NX: Performance Rod

Components

COMPONENTS

ILLUSTRATION

*1

SUSPENSION TOWER DAMPER

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

Removal

REMOVAL

PROCEDURE

1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

Click here

2. REMOVE SUSPENSION TOWER DAMPER

(a) Remove the 2 nuts and the suspension tower damper from the vehicle.

Installation

INSTALLATION

PROCEDURE

1. INSTALL SUSPENSION TOWER DAMPER

(a) Install the suspension tower damper with the 2 nuts.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

2. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY

Click here

READ NEXT:

 Rear Suspension

 Performance Damper

ComponentsCOMPONENTS ILLUSTRATION *1 SUSPENSION TOWER DAMPER - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE REAR FLOOR FINISH PLATE Click

 Rear Coil Spring

SEE MORE:

 Starter Relay Circuit High (P0617-142)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0617-142 Starter Relay Circuit High An ST signal from the hybrid vehicle control ECU is on when the power switch is off. (2 trip detection logic) Wire harness or connector Hybrid

 Removal

REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR

© 2016-2026 Copyright www.lexunx.com