Lexus NX: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
If the main body ECU (multiplex network body ECU) is replaced, refer to Registration.
Click here .gif)
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
-
If the auxiliary battery voltage becomes low, rear mirror heater operation is canceled to prioritize supplying power to the power steering system.
for Manual Tilt and Manual Telescopic Steering Column: Click here
for Power Tilt and Power Telescopic Steering Column: Click here
| Symptom | Suspected Area | Link |
|---|---|---|
| RH side power mirror cannot be adjusted with power mirror switch | Outer rear view mirror assembly RH | |
| Outer mirror switch assembly | | |
| Harness or connector | - | |
| LH side power mirror cannot be adjusted with power mirror switch | Outer rear view mirror assembly LH | |
| Outer mirror switch assembly | | |
| Harness or connector | - | |
| Power mirror cannot be adjusted with power mirror switch | Outer mirror switch assembly | |
| Harness or connector | - | |
| Mirror heater does not operate | Proceed to "Mirror Heater does not Operate with Rear Defogger Switch" | |
| Symptom | Suspected Area | Link |
|---|---|---|
| Power retract mirrors do not operate | Proceed to "Power Retract Mirrors do not Operate with Power Retract Mirror Switch" | |
| AUTO power retract mirrors do not operate | Proceed to "AUTO Power Retract Mirrors do not operate" | |
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU), INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY *1 Main Body ECU (Multiplex Network Body ECU) - - (a) Remove the main body ECU
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT AUXILIARY BATTERY VOLTAGE (a) Measure the auxiliary battery voltage with the power switch off. Standard voltage: 11 to 14 V If th
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG (a) Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder assembly
Switch Lights of Remote Touch Always Illuminate or cannot be Controlled Using Rheostat
DESCRIPTION Power is supplied to the remote touch illumination when the light control switch is in the tail or head position. HINT:
When the remote touch is in self check mode, the switch illumination on the remote touch may remain on.
If any illumination controlled by the rheostat switch has a
