Lexus NX: Power Mirror Control System (w/o Memory)
Lexus NX Service Manual / Vehicle Exterior / Mirror (ext) / Power Mirror Control System (w/o Memory)
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Mirror Heater does not Operate with Rear Defogger Switch
- Power Retractable Mirrors do not Operate with Power Retract Mirror Switch
- AUTO Power Retract Mirrors do not operate
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY LH *2 OUTER REAR VIEW MIRROR ASSEMBLY RH *3 OUTER MIRROR LH *4 OUTER MIRROR RH *5 NO. 2 ENGINE ROOM RELAY BLOCK
System Diagram
SYSTEM DIAGRAM Power Mirror Control System Mirror Heater System
System Description
SYSTEM DESCRIPTION FUNCTION OF MAIN COMPONENT Component Function Outer rear view mirror assembly Vertical mirror motor Moves the mirror surface vertically in accordance with the vertical
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STIFFENING CRANKCASE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. *a Protrusion Height (a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop. Standard protrusion height: 4.3 to 5.3 mm (0.169 to 0
Linear Solenoid Valve Offset Learning undone (C1345,C1368)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) stores and corrects the individual differences in the brake pedal stroke sensor assembly, actuator solenoids, and stroke simulator solenoid. Perform initialization and calibration of the linear solenoid valve if any of th
© 2016-2026 Copyright www.lexunx.com
