Lexus NX: Radio Antenna Cord
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Type A *B for Type B *1 NO. 1 ANTENNA CORD SUB-ASSEMBLY *2 UPPER INSTRUMENT PANEL SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - -
Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before serving. Click here NOTICE: After turning the power switch off, there may be a waiting time before disconnecting
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 4 ANTENNA CORD SUB-ASSEMBLY (a) Attach the 2 clamps and guide to install the No. 4 antenna cord sub-assembly. (b) Install the bolt and attach the 2 clamps to inst
SEE MORE:
Fail-safe Chart
FAIL-SAFE CHART If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection. DTC Code Component Fail-Safe Operation Fail-Safe Deactivation Condition P0031 P0032 P101D Air fuel ratio sensor heater The EC
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT LUMBAR POWER SEAT SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 3 (H) - 5 (B) Hold switch on Below 1 Ω 1 (R) - 2 (E) 2 (E) -
© 2016-2026 Copyright www.lexunx.com
