Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | ENGINE COOLANT TEMPERATURE SENSOR | *2 | NO. 1 ENGINE COVER SUB-ASSEMBLY |
| *3 | GROUND WIRE | *4 | GASKET |
.png) | N*m (kgf*cm, ft.*lbf) : Specified torque | * | For use with ball joint lock nut wrench |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR (a) Disconnect the engine coolant tempera
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR *a Component without harness connected (Engine Coolant Temperature Sensor) *b Resistance *c Temperature *d Accepta
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the engine coolant temperature sensor. Click here PROCEDURE 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
SEE MORE:
SLA Linear Solenoid (C1211,C1212,C1225-C1228,C1352,C1353,C1356,C1357)
DESCRIPTION Each solenoid adjusts pressure which affects each wheel cylinder according to signals from the skid control ECU (brake booster with master cylinder assembly) and controls the vehicle. The master cut solenoid is closed and blocks the regulator pressure from the electronically controlled b
Disassembly
DISASSEMBLY PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Do not reuse parts which have reduced fastening ability due to thread damage.
When installing components, make sure that the wire harness is not pinched or pulled.
Do not use sol
© 2016-2026 Copyright www.lexunx.com
