Lexus NX: Rear Upper Arm
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o AVS *B w/ AVS *1 REAR SPEED SENSOR LH *2 REAR SUSPENSION ARM COVER LH *3 REAR UPPER CONTROL ARM ASSEMBLY LH *4 PARKING BRAKE WIRE BRACKET
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR UPPER CONTROL AR
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 5 (S) - 1 (GND) EV mode switch pushed and held Below 10 Ω
Removal
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Click here 2. DRAIN ENGINE COOLANT Click here 3. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY (a) Remove the bolt and rotate the hook connector as shown in the illustration. (b) Disconnect the air cond
© 2016-2026 Copyright www.lexunx.com
