Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | w/o AVS | *B | w/ AVS |
| *1 | REAR SPEED SENSOR LH | *2 | REAR SUSPENSION ARM COVER LH |
| *3 | REAR UPPER CONTROL ARM ASSEMBLY LH | *4 | PARKING BRAKE WIRE BRACKET |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with ball joint lock nut wrench |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR UPPER CONTROL AR
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor) (a) Disconnect the I56 windshield wiper relay assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Make sure to use Toyota Genuine Windshield Glass Adhesive (High Modulus Type) or an equivalent high modulus adhesive. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque speci
© 2016-2026 Copyright www.lexunx.com
