Lexus NX manuals

Lexus NX: Reassembly

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Clearance Light Assembly (for Bulb Type Turn Signal Light) / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL FRONT TURN SIGNAL LIGHT BULB

(a) Install the front turn signal light bulb to the bulb socket.

(b) Align the matchmark of the bulb socket to the unlock position mark, and then rotate the bulb socket clockwise until the lock position mark to connect the bulb socket.

*a

Matchmark

*b

Unlock Position Mark

*c

Lock Position Mark

Clockwise

READ NEXT:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL CLEARANCE LIGHT ASSEMBLY LH (a

 Clearance Light Assembly (for Led Type Turn Signal Light)

 Components

COMPONENTS ILLUSTRATION *1 CLEARANCE LIGHT ASSEMBLY LH - -

SEE MORE:

 Registered Device cannot be Deleted

PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

 Inspection

INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (a) for Manual Seat: (1) w/o Seat Heater System: Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 2 (RBR-) - 5 (RBR+)

© 2016-2026 Copyright www.lexunx.com