Lexus NX: Registration
REGISTRATION
CAUTION / NOTICE / HINT
NOTICE:
The Vehicle Identification Number (VIN) must be input into a replacement ECM.
HINT:
The VIN is a 17-digit alphanumeric vehicle identification number. The Techstream is required to register the VIN.
PROCEDURE
1. DESCRIPTION
HINT:
This registration section consists of 2 parts: Read VIN and Write VIN.
(a) Read VIN: This process allows the VIN stored in the ECM to be read in order to confirm that the 2 VINs, provided with the vehicle and stored in the vehicle ECM, are the same.
(b) Write VIN: This process allows the VIN to be input into the ECM. If the ECM is replaced, or the ECM VIN and vehicle VIN do not match, the VIN can be registered, or overwritten in the ECM by following this procedure.
2. READ VIN
(a) Confirm the vehicle VIN.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Read.
Powertrain > Engine and ECT > Utility| Tester Display |
|---|
| VIN |
3. WRITE VIN
(a) Confirm the vehicle VIN.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Powertrain / Engine and ECT / Utility / VIN / VIN Write.
Powertrain > Engine and ECT > Utility| Tester Display |
|---|
| VIN |
READ NEXT:
Initialization
INITIALIZATION Inspection After Repair Perform learning value reset and idle learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an
Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously m
Readiness Monitor Drive Pattern
READINESS MONITOR DRIVE PATTERN PURPOSE OF READINESS TESTS
The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emission related components, and indicate any detected a
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR HEADER SPEAKER ASSEMBLY NOTICE: Do not touch the cone part of the speaker. (a) Temporarily install the speaker by attaching the clip of the speaker to the vehicles body. (b) Install the rear header speaker assembly with the bolt. Torque: 7.5 N·
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main
