Lexus NX: 2ar-fxe (engine Control)
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Control)
- Air Fuel Ratio Sensor
- Camshaft Oil Control Valve
- Camshaft Position Sensor
- Crankshaft Position Sensor
- Ecm
- Engine Coolant Temperature Sensor
- Heated Oxygen Sensor
- Ignition Coil And Spark Plug
- Ignition System
- Knock Sensor
- Manifold Absolute Pressure Sensor
- Mass Air Flow Meter
- Relay
- Sfi System
- Throttle Body
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR FUEL RATIO SENSOR *2 INVERTER RESERVE TANK ASSEMBLY *3 NO. 1 EXHAUST MANIFOLD HEAT INSULATOR *4 WIRE HARNESS *5 RADIATOR HOSE CLAMP - -
Removal
REMOVAL PROCEDURE 1. DISCONNECT WIRE HARNESS Click here 2. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Click here 3. DISCONNECT INVERTER RESERVE TANK ASSEMBLY Click here 4. REMOVE AIR FUEL RA
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 REAR DECK FLOOR BOX *3 NO. 3 DECK BOARD SUB-ASSEMBLY *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 MULTIPLEX TILT AND TELESCOPIC ECU *2 LOWER STEERING COLU
Components
COMPONENTS ILLUSTRATION *1 COLUMN HOLE COVER SILENCER SHEET *2 COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY *3 ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY *4 LOWER STEERING COLUMN COVER *5 NO. 1 AIR DUCT *6 NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY *7
© 2016-2026 Copyright www.lexunx.com
