Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
(a) for Sport Package:
Click here .gif)
(b) except Sport Package:
Click here
2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
NOTICE:
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
(a) Remove the 2 bolts and screw.
.png) | Bolt |
.png) | Screw |
(b) Detach the guide and remove the millimeter wave radar sensor assembly.
READ NEXT:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT CAUTION: Radiofrequency radiation exposure information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Th
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one. PROCEDURE 1. INS
SEE MORE:
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION NOTICE:
When using the Techstream with the power switch off to confirm DTCs or Data List information related to the smart access system with push button start, the Techstream may not operate unless either of the following is performed: 1) Turn a courtesy light switch
Operation Check
OPERATION CHECK INITIAL CHECK (a) Power switch on (IG) (intuitive parking assist system off). (b) Intuitive parking assist system on and check an indication state of the vehicle mark. OK: The initial check is performed for approximately 5 seconds after the system turns on, and then the system switc
© 2016-2025 Copyright www.lexunx.com
