Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE BACK DOOR CENTER GARNISH
Click here 
2. REMOVE BACK DOOR SIDE GARNISH LH
Click here
3. REMOVE BACK DOOR SIDE GARNISH RH
HINT:
Use the same procedure described for the LH side.
4. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
5. REMOVE PULL HANDLE (w/ Power Back Door)
Click here
6. REMOVE BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
7. REMOVE BACK DOOR FINISH COVER RH (w/o Power Back Door)
HINT:
Use the same procedure described for the LH side.
8. REMOVE BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
9. REMOVE BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
10. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Click here
11. REMOVE BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)
| (a) Disconnect the connector. |
|
(b) Detach the clamp.
(c) Remove the 4 bolts and back door lock assembly.
12. REMOVE BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
| (a) Disconnect the connector. |
|
| (b) Remove the 3 bolts and back door lock assembly. |
|
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door) (a) Check the operation of the door lock motor. (1) Move the back door lock assembly to the lock position. (2) Apply au
Installation
INSTALLATION PROCEDURE 1. INSTALL BACK DOOR LOCK ASSEMBLY (w/ Power Back Door) NOTICE:
When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
When insta
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
*1: w/ Manual (SOS) Switch
*2: It is connected, but not used *3: w/o Manual (SOS) Switch #: There is no wire color information I151-1 (GND1) - Body ground W-B - Body ground
Rear Wheel House Plate
ComponentsCOMPONENTS ILLUSTRATION *1 REAR WHEEL FRONT HOUSE PLATE LH - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL FRONT HOUSE PLATE LH (a) Remove
