Lexus NX: Freeze Frame Data
FREEZE FRAME DATA
FREEZE FRAME DATA
(a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch off.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes(e) Select a DTC to display its freeze frame data.
Body Electrical > Front Recognition Camera (Front Lighting Control)| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Total Distance Traveled | Actual driving distance | 0 to 16777215 | Roughly the same as the actual driving distance | - |
| Total Distance Traveled - Unit | Actual driving distance unit | km or mile | Displays the current actual driving distance unit | - |
| AHB/AHS Information | Lighting system state | unknown, AHB or AHS | Displays lighting system state | - |
CLEAR FREEZE FRAME DATA
NOTICE:
Clearing the DTCs will also clear the freeze frame data.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch off.
(c) Clear the DTCs and freeze frame data.
(d) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Clear DTCs.
Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCsREAD NEXT:
Fail-safe Chart
FAIL-SAFE CHART LED HEADLIGHT SYSTEM The headlight assembly (light control LED ECU) operates in fail-safe mode if any of the following abnormalities are detected. Item Abnormality Detection Condi
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lighting System DTC No. Detection Item Link B1244 Light Sensor Circuit Malfunction B2430 LED Headlight LH Circuit Malfunction B2431 LED
SEE MORE:
Diagnosis System
DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here INSPECT AUXILIARY BATTERY VOLTAGE (a) Measure the auxiliary battery voltage with the power switch off. Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the auxiliary battery.
Operation Check
OPERATION CHECK INITIAL CHECK (a) Power switch on (IG) (intuitive parking assist system off). (b) Intuitive parking assist system on and check an indication state of the vehicle mark. OK: The initial check is performed for approximately 5 seconds after the system turns on, and then the system switc
