Lexus NX: Removal
REMOVAL
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Click here .gif)
2. REMOVE AIR CONDITIONER PRESSURE SENSOR
| (a) Disconnect the connector. |
|
| (b) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor. NOTICE: Seal the openings of the removed parts using vinyl tape to prevent the entry of moisture and foreign matter. |
|
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL AIR CONDITIONER PRESSURE SENSOR (a) Remove the vinyl tape from the liquid pipe sub-assembly and the connecting part of the air conditioner pressure sensor. (b) Apply
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE:
After the power switch is turned off, there may be a waiting time before disconnecting the negative (-
SEE MORE:
Driving assist systems
To keep driving safety and performance,
the following systems operate
automatically in response to
various driving situations. Be aware,
however, that these systems are
supplementary and should not be
relied upon too heavily when operating
the vehicle.
Summary of the driving assist
systems
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL REAR SEAT WIRE LH (for LH Side) (a) Attach the 2 clamps to install the rear seat wire LH. (b) Connect the 2 connectors. 2. INSTALL FOLD SEAT CONTROL
© 2016-2026 Copyright www.lexunx.com
