Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT SIDE PANEL LH
Click here .gif)
2. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
3. REMOVE TRIP SWITCH
| (a) Using a screwdriver, detach the 2 claws and remove the trip switch. HINT: Tape the screwdriver tip before use. |
|
.png)
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT TRIP SWITCH *1 ODO TRIP Switch *a Component without harness connected (Trip Switch) (a) Check the resistance. Measure the resistance according to the val
Installation
INSTALLATION PROCEDURE 1. INSTALL TRIP SWITCH (a) Attach the 2 claws to install the trip switch. 2. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 3. INSTALL INST
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a
Engine ECU Communication (U0100,U0126,U0140,U0163,U0233,U1110)
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly. HINT: If CAN communication system DTCs are stored, they may also be stored in other systems.
*1: w/ Blind Spot Monitor System
*2: w/ LEXUS Parking Assist
© 2016-2026 Copyright www.lexunx.com
